Easy Setup

Home » Easy Setup » Installation Instruction

Easy Setup

We are 100% confident that you will be satisfied with your final outcome, as much planning and development on our part has been dedicated into making this customized large format print possible for your adobe.

Kindly take a moment to read the simple instructions to ensure the print for your door is installed with no difficulty.

DimenzionArt^®'s 3D-door stickers are printed to standard international door size measuring 210 cm (H) x 90 cm (W). Only doors with flat surfaces are recommended for your 3D-door sticker transformation. Doors with wood, metal, glass and plastic surfaces are most suitable to this innovative makeover.

Pre-installation Instruction

Basic tools
Additional tools besides the squeegee - a cutter, measuring tape and 2" adhesive tape.

Get a DIY partner / buddy
Get your best buddy to assist you on this DIY installation.

Remove your doorknob
Use a standard screwdriver to remove doorknob.

Prepare door surface for better result
Sandpaper door surface, clean with a damp cloth and leave it to dry.

Installation Instruction

Measure door dimension Get the right measurement for door's height and width.
	Trim top & one of the sides of print to size Leave 1" extra print for the top and side. Do not trim from the bottom of the door sticker to ensure the right perspective.
Position the door sticker against the door Aligned the lower edge of sticker to the bottom edge of the door. Position the sticker vertically and centralize it against the door for the right positioning. Apply adhesive tape for support of door sticker Apply a small amount of adhesive tape on the top and sides of the sticker to the door to help you hold on to the correct position.
	Start from the top Beginning from the top, gently separate sticker from protective layer by initially peeling off only 8" - 12" downward.
Gently apply squeegee onto door sticker Gently rub the sticker unto the surface of the door with combination of left / right movement and occasionally rub using vertical movement when necessary. Gently remove trapped bubble Easily press trapped bubble to the edge of the sticker with the squeegee.
	Trim off excess on the top & sides Once the sticker is completely attached to the door, trim off the excess on the top and sides.
Trim off sticker over doorknob hole Trim off the door sticker around the hole for the doorknob. Once the doorknob is in placed, the exposed edges will be completely concealed.